WB Exterior Solutions - Roofing Company in St. Peters, MO

🛡️ Local Homeowner Special: Annual roof scans & 2x gutter cleanings for $49/mo. Call (636) 874-8808

Roof Replacement and Siding Cost in Tarrant County, TX (2026 Guide)

What a New Roof or New Siding Actually Costs in Tarrant County

Tarrant County pairs an older replacement market with fast growth. Fort Worth and Arlington hold large numbers of homes built from the 1980s through the 2000s, and those roofs are now at prime replacement age. Keller, Haslet, North Richland Hills, Hurst, Euless, Bedford, and the growth corridors in north Fort Worth add newer subdivisions that still take repeated hail. The county averages several severe hail events a year, so storm wear and simple age often arrive at the same time. This guide prices roof replacement, siding, and gutters for Tarrant County homes from a published rate card adjusted for the Tarrant County market, the same approach our instant estimator uses when it measures a home by satellite.

Run the Instant Estimator

Roof Replacement Cost in Tarrant County

The baseline is architectural shingles, standard across Tarrant County subdivisions. The estimator rate is $600 per square (100 square feet of roof) on our Missouri base rate card, with the Tarrant County market factor of 0.95 applied, which works out to about $570 per square installed before pitch and complexity adjustments. The estimator reads your roof's pitch, squares, and complexity from satellite measurement, so steep two-story roofs in Keller and Arlington price differently from single-story roofs in older Fort Worth neighborhoods, correctly.

Home size	Typical roof size	Architectural shingle replacement
1,500 sq ft	17 to 22 squares	$9,700 to $12,500
2,000 sq ft	22 to 28 squares	$12,500 to $16,000
2,500 sq ft	27 to 34 squares	$15,400 to $19,400
3,000+ sq ft	33 to 42 squares	$18,800 to $23,900

These ranges are estimates derived from the rate card, not quotes. Homes with multiple gables, dormers, and steep rear slopes land high in their band. Your exact figure comes from the satellite measurement of your home, and the local pro assigned to your project confirms it on site in writing before any contract.

Siding Cost in Tarrant County

Original siding on 1980s, 1990s, and early 2000s homes in Fort Worth, Arlington, Hurst, and Euless is reaching the end of its service life, and hardboard siding failures are common in this county. Many homes mix brick with siding on upper and rear elevations, so partial residing is common and should be priced by actual wall area, not by a whole-house guess. County-adjusted estimator rates per square of siding (100 square feet of wall):

Vinyl lap siding: about $708 per square
LP SmartSide or James Hardie lap siding: about $926 per square
Board and batten: about $993 per square

A typical 2,000 sq ft Tarrant County home carries 18 to 23 squares of siding, putting a full vinyl residing at roughly $12,700 to $16,300 and a Hardie or LP residing at roughly $16,700 to $21,300. Fiber cement holds up well against Texas heat and hail and is a common upgrade choice in Keller, Southlake-adjacent neighborhoods, and newer Fort Worth subdivisions. Your assigned local pro verifies wall measurements and existing condition on site before final pricing.

Gutters

Seamless aluminum gutters run about $11.40 per linear foot for 5-inch and about $14.25 per linear foot for 6-inch with the Tarrant County adjustment applied. Most Tarrant County homes take 120 to 180 linear feet, so full replacement usually lands between about $1,400 and $2,550. Roofs here shed large water volume in spring storms; oversized downspouts are worth the small upgrade on two-story homes and on any long eave that drains to one outlet.

Storm and Insurance Notes for Tarrant County

Texas policies usually carry a wind and hail deductible of 1% to 2% of dwelling value. On a $450,000 home that is $4,500 to $9,000 before coverage starts, so knowing your roof's real condition and replacement cost before a storm is a financial advantage. Document first, file second: a dated inspection with photos protects your claim and your options. The estimator gives you an itemized written price to hold against any adjuster scope, and your assigned local pro documents storm damage in the format carriers expect.

Local Permit Notes for Tarrant County

Permit rules split sharply by address in Tarrant County. Unincorporated Tarrant County does not require a roofing permit. Major municipalities do set their own rules. In Fort Worth, the city charges a flat roofing permit fee of about $175, and contractors must maintain local contractor registration and provide proof of general liability insurance before pulling permits. Arlington and the mid-cities set their own permit and registration requirements. Your assigned local pro confirms the rule for your exact city and address before work starts, so an unincorporated address is not priced or scheduled as if it were inside Fort Worth.

Tarrant County FAQs

My roof is 15 to 20 years old and looks fine from the street. Should I care?
Yes. In Tarrant County, a roof in that age range has usually taken several hail events, and granule loss from hail bruising shortens its remaining life even when it is not leaking yet. Many carriers also restrict coverage terms on older roofs. A satellite estimate tells you where you stand before storm season forces the question.

Does the estimator work in unincorporated Tarrant County and newer growth areas?
Yes. It measures from satellite imagery, so it works the same in Haslet, Keller, and unincorporated Tarrant County as it does in Fort Worth. Acreage homes and metal outbuildings are priced by the local pro on site; the estimator handles the house.

How is the Tarrant County price calculated?
The estimator applies a Tarrant County market factor of 0.95 to our Missouri base rate card and multiplies by your measured roof or wall area. You see the itemized result on screen, and the assigned local pro confirms the final price on site. One line on your estimate states the adjustment plainly, so there is no hidden math.

Who performs the work on my home?
WB Exterior Solutions runs the estimating and assignment. Outside Missouri, work is performed by independent locally licensed contractors. You get one vetted local pro assigned to your project in Tarrant County, not a rotation of crews, and that pro confirms your quote on site and stands behind the installation.

What happens after a big hail storm, when every roofer in Fort Worth is booked?
Storm volume spikes demand across the Metroplex and schedules stretch. Homeowners who already have a measured, written price and an assigned pro move first. Running the estimator before storm season puts your numbers in hand while everyone else is still waiting for a callback.

Texas County Cost Guides

Get Your Tarrant County Price

Run the instant estimator for an itemized price on your Fort Worth, Arlington, Keller, Haslet, or anywhere-in-Tarrant-County home. About a minute, measured off your actual roof, no obligation.

Run the Instant Estimator

Frequently Asked Questions

How much does a roof replacement cost in Tarrant County?

WB's estimator prices Tarrant County roofs off the same published shingle schedule used in Missouri (architectural shingles at $500 to $685 per square depending on tear-off), with local market pricing for Tarrant County built into the estimator. Run your address through the instant estimator linked on this page for the range on your measured roof.

How do I get an exact roof price in Tarrant County?

Run the free instant estimator linked from this page: it measures your roof by satellite and applies Tarrant County's local market pricing. WB is a Missouri contractor; work outside WB's home market is routed to an exclusive vetted local partner under WB's program, and that routing is stated up front before you commit to anything.

What drives roof replacement cost the most?

Measured squares, pitch, and tear-off layers, in that order. On WB's schedule a one-layer tear-off moves architectural shingles from the $500 to $600 per square band to $555 to $685 per square, and steep pitch adds its own band. The estimator counts all three from the satellite measure.